Attaching THE BAIT SHUTTLE™ to the Line

THE BAIT SHUTTLE™ is easy to use. Decide on what depth you wish to fish. EXAMPLE: If you want to fish at 18" in depth, measure up 18" from the bottom of the hook. Hold the shuttle upside down in one hand. Take the line and make a small loop between your index finger and thumb. (1) Simply insert the looped line from inside the shuttle and push the looped line through the upper hole and pull the looped line through to the outside of the shuttle. (2) After pulling the looped line through the upper hole, take the looped line and reinsert or push it back through the lower hole from outside of the shuttle. (3) After pushing the looped line back through the outside hole grab the looped line from the inside of the shuttle pull it up and insert or place one side of the looped line into one slit and the other side of the looped line into the other slit. (4) Pull both sides of the line tight; making sure the line is secured under the outside ledge or lip of the shuttle. The shuttle is now secure and will not slip up or down your line.

Insert any lead weight or split shot into the inside of the shuttle. Place a baited hook on top of the weight being used. Let any excess line hang over the side of the shuttle. Reel the shuttle to the top of the pole to cast. You are now ready to cast safely without hooking others or objects, throw more accurately than other bobbers you have used and as far as you want to cast, WITHOUT LOSING YOUR BAIT! Your bait is protected and delivered intact and upon splashdown the shuttle will gently roll over and safely dispense the bait and any weight from the shuttle. THE BAIT SHUTTLE™ will now serve as a BOBBER. (See below for The SINKER model). For illuminated night time fishing break and shake a GLOW-STIX TM and the push into the receptacle on top of the shuttle until it will go no further. You are now ready to fish at night and see the shuttle. When needed replace with another GLOW-STIX TM. GLOW-STIX TM may also be used for other purposes.

If you are using THE SINKER model (attached as above), after splashdown your baited hook and weight will dispense as above and then slowly sink to the bottom. This is designed for those who want to fish on the bottom and get their bait there intact.

To take the shuttle off of your line, simply push the line out from the inside and grab a hold of the line below the lip, lift up and take the line out of the slits and pull your line back through the hole. Any further questions please see THE BAIT SHUTTLE